With the width of the vehicle worked out, it is time to make it drive like a crawler.
To slow the Slash down to believable crawler speed I actually kept the stock gearing in place (19.23 Final Drive Ratio for the brushed 4×4). Then I added a RC4WD 1:3 Gear Reducer, which would change the final drive ratio to almost 60:1 – a popular ratio amongst crawlers and close to the TRX-4 low-speed setting.
The gear reducer is normally a bolt on part, but there were some tweaks I had to do to get it to fit the Titan 550 motor. First the receiver hole in the gear reducer is too small fo the 550’s standard 13mm bearing enclosure (the part that sticks out right before the motor shaft). Which is strange because the age-old Tamiya 540 motor also specifies 13mm for this part of the motor.
